DigiDesign AVoption|V10 Especificaciones descargar pdf (Pagina 20)

Avid Video Peripherals Guide14

Connecting Avid DNA Video

Peripheral Hardware

To connect Avid DNA video peripheral hardware:

1 Connect the power cable for the Avid DNA

video peripheral.

2 Connect one end of the FireWire cable to the

Host port on the Avid DNA video peripheral,

and connect the other end to any internal

FireWire port on your computer.

Connecting a DV Device

To connect a DV device to the Avid DNA video

peripheral:

■ Connect one end of the FireWire (1394) cable

to the DV port on the Avid DNA video periph-

eral, and connect the other end to any available

FireWire port on the DV Device.

Connecting Serial Digital Video

Input and Output

(AVoption|V10 only)

To connect the output of a serial digital video

source to the AVoption|V10:

■ Using a BNC cable, connect the serial digital

output from a digital video source to SDI IN on

the AVoption|V10 breakout box.

To connect the serial digital video output from the

AVoption|V10 to a digital video deck:

■ Using a BNC cable, connect SDI OUT 1 or 2 on

the AVoption|V10 breakout box to the serial dig-

ital input of the video deck.

Connecting a SYNC I/O

The SYNC I/O is required for Pro Tools|HD sys-

tems with an Avid DNA video peripheral. For

more information on conﬁguring and using the

SYNC I/O, see the SYNC I/O Guide.

Video Reference In

Connect a BNC cable to one of the Video Ref

ports on the SYNC I/O and to a black burst

(house video reference) generator.

All FireWire ports on Digidesign-qualified

computers are connected to the same bus,

and the Avid DNA video peripheral must be

the only device attached to this bus. There-

fore, you must install a PCI FireWire card if

you need to connect other FireWire devices.

See Appendix B, “PCI Slot Configurations

for Avid DNA Video Peripherals” for more

information on where to connect a PCI

FireWire card.

It is critical to follow the card installation

directions in Appendix B, “PCI Slot Config-

urations for Avid DNA Video Peripherals.”

All Firewire decks and cameras that are

connected to Avid DNA video peripheral

must be powered on after powering on the

Avid DNA video peripheral.

AVoption|V10 does not support audio em-

bedded in the SDI stream.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 55 56

Comentarios a estos manuales

Sin comentarios