DigiDesign MachineControl Especificaciones descargar pdf (Pagina 27)

Chapter 4: Remote 9-Pin Deck Emulation Mode 23

chapter 4

Remote 9-Pin Deck Emulation Mode

Remote 9-Pin Deck Emulation mode makes

Pro Tools operate as a virtual tape deck, support-

ing most standard Sony P2 9-pin commands.

For a list of supported commands, see “9-Pin

Commands” on page 27. By default, Pro Tools

emulates a Sony BVW-75 model video deck. You

can also configure Pro Tools to emulate other

machines. For more information, see “Alternate

Machine Types” on page 24.

Generating Time Code in Remote 9-Pin

Deck Emulation Mode

Pro Tools with MachineControl and the

SYNC I/O can generate frame-edge aligned time

code at 1x play speed while in Remote 9-Pin

Deck Emulation mode.

Conﬁguring Remote 9-Pin

Deck Emulation Mode

To conﬁgure Pro Tools for Remote 9-Pin Deck

Emulation mode:

1 Choose Setups > Peripherals, and click the

Synchronization tab.

2 Make sure the SYNC I/O (or USD) is the se-

lected Synchronization device, enabled on the

DigiSerial port.

3 Click the Machine Control tab at the top of

the Peripherals dialog.

4 In the 9-Pin Remote section, click Enable.

5 Choose the appropriate port from the Port

menu.

6 Choose the appropriate machine proﬁle from

the Machine ID pop-up menu.

7 Do one of the following:

• Select Chase LTC to have Pro Tools chase

the master time code source.

• Deselect Chase LTC to have Pro Tools and

the SYNC I/O provide the master time code

signal.

8 Click OK.

For instructions on connecting Pro Tools for

Remote 9-Pin Deck Emulation mode, see

Chapter 2, “Installing and Configuring

MachineControl.”

Remote 9-Pin Deck Emulation mode settings

In addition to the option to chase LTC, Re-

mote 9-pin Deck Emulation mode also pro-

vides a preference setting to follow or ignore

remote track arming commands. For more

information, see “Ignore Track Arming

Commands” on page 26.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 51 52

Comentarios a estos manuales

Sin comentarios

DigiDesign MachineControl Especificaciones Pagina 27

Comentarios a estos manuales

Relacionado con productos y manuales para Software DigiDesign MachineControl