DigiDesign MachineControl Guía de usuario descargar pdf (Pagina 34)

MachineControl Guide30

Time Code Inaccuracy

Problem

The time code locations shown in the Selection

and Position Indicator boxes do not match ma-

chine time code.

Possible Solutions

This problem can be caused by a number of

things. Sometimes the Time Code times re-

ported by machines are not in sync with the

time code that gets played out of their time code

ports. (One example of this is when the ma-

chine's time code reader is looking at VITC

while Pro Tools is chasing LTC.)

◆ If the values get progressively farther and far-

ther apart, check the frame rate. Make sure you

have set Pro Tools to the same frame rate as the

movie/machine frame rate. Also check the

frame format (drop or non-drop).

◆ If the values differ by a signiﬁcant margin

(such as an hour or more), perhaps the Start

Frame number isn’t set correctly. Choose

Setups > Machine Setup and check the Pro Tools

Start Frame number.

Remote Mode

Problem

While recording in Remote mode, Pro Tools is

consistently a frame (or more) early, or late, for

punch in or out.

Solution

Adjust the Punch In/Out frame offset. To do

this, choose Setups > Preferences > Operations

and configure the Remote Mode Offset settings.

Problem

Remote is mode unavailable, or doesn’t seem to

be recording.

Possible Causes and Solutions

◆ You must have a USD set to the proper frame

and sample rate. You must also be in Generate

mode and in Video Clock Reference.

◆ Make sure you have set Transport = Remote.

◆ Make sure the Pro Tools Online button is blue.

If the Online button is blinking, Pro Tools is not

properly communicating with the controller.

Operation Preferences for MachineControl

Punch In/Out

Frame Offset

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 45 46

Comentarios a estos manuales

Sin comentarios

DigiDesign MachineControl Guía de usuario Pagina 34

Comentarios a estos manuales

Relacionado con productos y manuales para Software DigiDesign MachineControl